Lake Norman Real Estate Shoreline Characteristics


By submitting this information, you provide express written consent to Lake Realty and our affiliates (the “Company”) sending you future information, contacting you for telemarketing purposes using the information (including any phone numbers) you have or will provide us, and monitoring and recording these communications to assure the quality of service or for other reasons.  This means the Company may contact you via residential number, mobile number and/or text messaging (including use of automated dialing equipment and pre-recorded calls). You are not required to give your consent as a condition of making a purchase with the Company. Additional information can be found in our Privacy Policy.


Lake Norman NC Shoreline Characteristics to Prevent Erosion

Shoreline Characteristics to Consider

  • Classification of the shoreline based on the Duke Energy Shoreline Management Plan
  • Existing vegetation
  • Fluctuating Water Levels
  • Wave energy (from boat traffic and wind)
  • Slope configuration above and below the waterline
  • Soil type and condition above and below the waterline
  • Primary source of erosion
  • Amount of sunlight exposure
  • Shoreline maintenance requirements

Shoreline Classification

When planning a shoreline stabilization project, a Duke Energy lake representative should be contacted to determine the Duke Energy classification of the shoreline based on Duke Energy’s Shoreline Management Plan. The shoreline classification and bank height will help classify which stabilization methods can be constructed. Shorelines are classified as environmental, natural, impact minimization zones, and other, by the Duke Energy Shoreline Management Plan, depending on their current use, vegetation cover, habitat value, water depth, substrate and location. Depending on the shoreline classification and bank height only certain stabilization techniques will be permitted by the Duke Energy Shoreline Management Plan, some of these classifications may have additional shoreline modification restrictions.

Existing Vegetation

Any existing vegetation should be saved and used as part of the erosion control plan, if possible. If the shoreline possesses existing vegetation, simply adding to the already established vegetation may solve the erosion problem. Obviously, the existing plant species have survived at the site, but the cause of any barren areas on the shoreline (e.g., vegetation and shallow topsoil may have been removed during a single storm event or the overhead canopy shades the barren area) should be determined. In either case, the surrounding area can be altered to re-establish lost vegetation.

When establishing vegetation, only native vegetation should be used. Planting native vegetation is recommended because they can be less expensive and offer a higher degree of transplant survival -- that means more shoreline protection. Planting native vegetation can be less expensive, offer a higher degree of transplant survival, and provide more shoreline protection than non-native plants. Non-native vegetation is not recommended because many of the species can out-compete native vegetation and negatively impact biodiversity. Aquatic invasive species such as hydrilla and water hyacinth can clog waterways, degrade water quality, restrict boat traffic and recreational water use, and disrupt groundwater flow. They can make lakes virtually unusable and require millions of dollars for continued aquatic plant management.

Water Level Fluctuations

Reservoirs typically have fluctuating water levels that cause various degrees of shoreline erosion. The fluctuations differ depending on several factors, including power generation, weather conditions, recreational use, regulatory agreements, municipal water needs and flood control. In reservoirs with little water level fluctuation, the waves can typically build up a natural terrace, which can deflect waves and create a calmer protective area where plants may be colonized. In reservoirs with high water fluctuation, a natural terrace cannot be built up without human intervention.

While the annual lake level range will vary from lake to lake on our river systems, the annual fluctuation of each lake will be relatively consistent from year to year. Lake levels are measured in feet. A full lake (also known as “full pond”) is considered 100 feet and is the designed maximum water level of the lake. It also corresponds to an elevation above sea level that varies between lakes. For example, a lake level of 97 feet means the water level at that time is three feet below full and three feet below the designed maximum sea level elevation.

The water fluctuation ranges create the normal full, low, and mean water levels for the lake which, in turn, determines the zones of the shoreline. The size of the zones will vary according to the range of the water levels in a given lake and the slope of the shoreline, therefore, will be site specific. This is tremendously important when determining which vegetation should be used to help ensure the highest degree of survival, and where along the shoreline the vegetation should be planted. While these zones may vary with weather conditions and power generation, the annual lake level ranges are an acceptable gauge to determine the zone locations. Occasionally, extreme lake levels occur and may cause problems. Different species of plants will grow and survive in different zones of the shoreline.

Wave Energy

A key factor in determining the appropriate stabilization technique to control erosion is the amount and strength of waves that reach the shoreline. Erosion caused by wave energy is related to wave height -- the higher the wave impacting the bank, the more erosion is likely to occur.
Wave height depends on three factors:

  • fetch (the distance the wind blows across a body of water until it reaches the shore)
  • water depth
  • wind speed

A greater fetch means a taller wave. In reservoirs, deeper water is typically located near the dam, and shallow water is upstream from the dam. The deeper the water the wind blows across, the greater the height of the wave that will affect the shore.

Project sites located where the banks are exposed to the main lake body will typically have a long wind fetch and are exposed to a high amount of wave energy. Sites located in coves may be protected from the wind and have little wave energy due to the wind, but boat traffic must be considered.

Locations that are continually exposed to high wave action due to wind and boat traffic may not be the best sites for planting native vegetation. The optimal solution may be a hard structural system, such as a seawall or riprap.

This information can also help determine if a temporary breakwater system, such as hay bales, will be needed to absorb some of the wave energy. The system will provide quiet water until the vegetation or erosion control systems are established. The wave energy can be determined in several ways: observation and general knowledge of the shoreline, consideration of the distance the wind blows across the water until it reaches the shore, the water depth and the amount of boat traffic around the site.

Shoreline Slope

Shorelines with steeper slopes tend to experience a bigger erosion effect on its banks from waves. Dropping the slope of a shoreline dissipates wave energy and lessens erosion. Normally, flatter slopes have less erosion and there are more options available to stabilize the shoreline. The slope of the shoreline will need to be determined to decide which erosion control system should be used and if any additional construction, such as backfilling, will be needed. Shoreline slopes steeper than 2:1 may require slope alterations before shoreline stabilization with bioengineering techniques or vegetation can be attempted. The slope of the shoreline can usually be estimated with general observations.

Soil Type and Condition

Shorelines commonly consist of organic material, clay, silt, sand, gravel, and rock. The extent of erosion depends on the specific makeup of the shoreline. The soil type will be vital in determining the bank's ability to battle erosion and, along with the soil condition, will be important in selecting the plants to be used. Some plants may not grow in certain types of soils because the roots may not be able to penetrate to find an adequate foothold. The soil type and condition can be analyzed free of charge by sending a sample to N.C. Department of Agriculture & Consumer Services Agronomic Division soil testing services. Local co-operative county extension offices should be able to provide materials and instruction on taking the sample.

Primary Erosion Source

Shoreline erosion is primarily caused by wave action driven by prevailing winds on the reservoir and, to a lesser extent, by upland runoff. Cuts, gullies or small ditches present on the bank or in the upland area, are good indicators of upland runoff. Lining the gullies with rock can help control upland runoff. Other methods to control shoreline erosion from upland runoff include drainage ditch modification or piping, limiting the amount of pedestrian traffic on the shoreline and enhancing the vegetation to increase the buffer. General observations of the site can usually identify the cause and location of erosion.

Sunlight Exposure

Sunlight is an essential ingredient in the growth and survival of plants. The amount of sunlight the shoreline and bank are exposed to determine what plants can be used as the erosion control method. Some plants tolerate partial shade while others require full sun. The quantity of sunlight can also explain why specific vegetation does not grow on the shoreline. The amount of sunlight can be estimated by identifying the direction the shoreline is facing.

Maintenance

Maintenance of the shoreline is an important consideration when selecting a stabilization technique. Maintenance includes weeding, pruning, removal and replanting vegetation. These maintenance requirements depend on the species of plants, weather conditions and soil conditions. Vegetative plantings and soil bioengineering control systems may require more maintenance than hard structural systems, but the maintenance cost of a vegetative system will usually be less expensive than the cost of repair and maintenance on a hard structure system. The effectiveness of a vegetative or soil bioengineering system typically improves over time -- the vegetation becomes more established and begins to grow and thrive as the plants become older. Hardened structures, however, deteriorate over time and may require extensive and expensive maintenance as their structures age.

Stabilization Techniques

Vegetative planting, soil bioengineering techniques, and structural systems are common methods used to stabilize and protect banks against erosion. Each may be used as a separate or combined method.

There are two types of general structural protection methods: those that reduce the strength of water against a shoreline, such as groins and jetties, and those that increase the shoreline’s resistance to erosive forces, such as riprap and seawall. Groins and jetties are not generally used on reservoirs, but vegetation can be an option to reduce the force of water against a shoreline.

Designs that use brushy vegetation or soil bioengineering alone or in combination with manmade structures protect the shoreline from water movement. The use of native vegetation provides a natural looking, environmentally friendly, economic solution and should be the first option considered for any shoreline erosion project.

For more information regarding Shoreline Stabilization Techniques visit the following link below:

Duke Energy Shore Stabilization Techniques